Gauges

Zeitronix Zt-2 Wideband A/F Ratio Meter & Datalogging System View larger

Zeitronix Zt-2 Wideband A/F Ratio Meter & Datalogging System

New

$345.00

More info

No matter if you have a stand alone engine management system, a piggy back fuel control or a carbureted engine. The Wideband Air Fuel Ratio Meter is a must for a serious tuner! Finally you can tune for more power, closer to the edge, precisely monitoring Air/Fuel ratio Boost, EGT, RPM and throttle position datalogging up to 9 hours of data with a blazing rate of 74 samples per seconds per graph. The ZDL software can be utilized as a real time display when using a basic Zt-2 kit without the hardware display.

Fully digital, smallest wideband O2 controller and datalogging system in the world!

Zt-2 is about the size of 1" thick business card. Extremely compact design for installation where space is a premium.

Zt-2 Specs

  • 0.1 AFR accuracy
  • Operating voltage 10V to 18V
  • Switching power supply for oxygen sensor heater
  • Precise sensor temperature control
  • Reverse polarity protection
  • Integrated fuse
  • Flexible Plug and Play Sensor Harness with a small, easy to route through the fire wall, connector
  • Wideband Oxygen Sensor included
  • Easy to install plug and play kit
  • Adjustable Narrowband Switching Point
  • Warning Alarms and Triggers

Inputs/Outputs:

  • Bosch Wideband O2 sensor
  • Linear Wideband Output AFR=Vx2+9.6
  • Nonlinear Wideband Output
  • Serial data output to the Zeitronix Wideband LCD Display
  • Serial data output for real time datalogging (PC laptop required)
  • RPM Input ( tachometer or primary side ignition coil input).
  • The RPM input works in any car and any ignition system. No additional adapters needed!
  • Simulated Narrowband Output to feed a stock ECU
  • Throttle Position Input
  • Boost Sensor Input
  • EGT Probe Input
  • User Input/Warning Output

Each Kit Includes:

  • Zt-2 Wideband Air/Fuel Ratio Meter
  • Wideband Oxygen Sensor
  • Sensor Harness
  • Signal Harness
  • PC Serial Cable
  • Datalogging Software
  • Installation Instructions
  • 2 pin EGT connector to retrofit your EGT probe.

MADE IN THE USA!