Maverick Pro Vented Catch Can

The Pro Vented Catch can eliminates 100% of any oil/vapor contamination that could enter the intake tract, intercooler plumbing or intercooler.  This set up eliminates the recirculating line that originally runs to the intake.  We've added a port that replaces the oil fill cap and then vent the valve cover.  This also ADDS horsepower by eliminating all the crankcase pressure.

**Buschur’s catch can/oil separator installation instructions **

The factory fittings that go to the air inlet and valve cover are extremely difficult to remove, don’t attempt to remove them.

Very carefully use a sharp knife/razor to gently cut the factory hose on each of those fittings.  Remove the hose, if you cut it length wise it will slide off easily.

Then simply push the supplied hose with our kit back onto the factory fittings.

You will replace your factory oil cap with the supplied cap/vent fitting.  You will need to re-use the factory o-ring from your factory oil cap on the supplied fitting.

The can mounts directly to the bolt closest to the engine on the coolant overflow bracket.  

The can will need drained occasionally.   Keep an eye on the how much the can accumulates over time.  Towing, altitude, temperature changes all effect how much will accumulate in the can.